Hello, I purchased a used Steadicam flyer (first gen I believe, grey arm?) and knew that the power cables from the battery plates to the LEMO connector (2-pin) was severed. My plan is to replace the cable harness to allow me to hook a LEMO to D-tap then a D-tap splitter box to hook up to a RED scarlet / monitor / bartek etc... I have a couple questions:1) Should I replace my two pin LEMO with a more modern three pin for power? Not sure if "more modern" is the correct term, it just seems to be in wider use.
2)How do I go about wiring both Anton Bauer battery mounts that were included on the sled to run up to that LEMO connector? I would like to be able to use 2 batteries on the bottom running together up the post to the power port. I'm not sure where to start on this, or if that is even an option (see included photos)
Any assistance would be appreciated to get me started.
Thank you