Search the Community
Showing results for tags 'super-post'.
-
Hello Everybody, As promised on a recent discussion on the forums ( http://www.steadicamforum.com/index.php?showtopic=17981&page=4 ) about super high mode conversion of Ultra2 rig, I share with you the video of me converting it to super high mode using its 4 stage telescoping post. Camera on the sled is a loaded magazine 435 along with 35mm Zeiss super speed MKIII lens and Arri clip-on matte-box. The conversion starts at 0:14. In total, going from normal to super high takes about 1 minute 45 seconds. Lens height achieved is 2,25 meters (I’m 1,75 meters tall) with the socket block raised on my Ultra2 vest and 23cm long arm post on my G-70 arm. If I were to put a 3rd battery and/or a dummy weight at the bottom of the sled I could have raised the camera another 15/20 cm using the full extent of the built-in super-post. The process of conversion is very strait forward. I first extend the telescoping posts fully –just shy of marking lines turning red- below the gimbal thus giving maximum amount of counter balance, then I extend the post located above the gimbal until I got neutral balance and I shorten it to give the rig a slightly bottom heavy balance. I check and correct the static balance using the motorized stage, do a drop test. And done! Normally I would also adjust the integral tilting stage; you can give me a time penalty of 15 seconds for it. This brings us to 2 minutes of conversion time from start to finish. Thank you for reading and have a nice day! PS for newbies: the drop time of 4+ seconds in super high mode might seem slow to you but with a sled this long you have huge amounts of inertia acting against the tilt and roll axis. So, a normal drop time of 3 seconds would be too bottom heavy for this kind of setup. PS for imperial system lovers: suck-it! Metric rules! Pun intended :) https://vimeo.com/64580595
- 6 replies
-
- 1
-
- Ultra2
- super-post
-
(and 4 more)
Tagged with: