Jump to content

Any good Atamos Shogun mounting options on the Ultra2?


John Hatcher

Recommended Posts

Has anyone found good way to mount the Shogun low on the sled either directly on and perpendicular to the center post, or off the monitor rods? It just gets cumbersome up top by camera and everything I usually have going on up there with cables, motors and what not.

 

 

Link to comment
Share on other sites

I'll check that out Alan. I know small rig has a rod offset 1/4 inch clamp, but it's 15 mm and those monitor rods are a little bigger...

 

You're right Alfeo, the spacing is different and Tiffen does have a block that will fit, but that's too expensive for me just for the shogun.

Link to comment
Share on other sites

  • 1 month later...
  • 1 year later...

Any luck on Frankensteining a solution? And I can confirm that the Clipper monitor rods are 16mm and I think the spacing just might be a bit over 100mm.

 

At this I'm banging my head against the wall to figure this out as I want to attach a Shogun Flame to my Clipper24 rig.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...