Jump to content

Model III Sled


Recommended Posts

  • Premium Members

Model III sled w/ telescoping post and side to side adjustment

Extra base with gutted electronics, wired for 12v

Dual Anton Bauer battery module, mounts on either base

Transvideo Cine Monitor !!!a SB, 1200nit SD w/ yoke and Anton Bauer mount

Pro(?) monitor arm

Panavision and Arri baseplates

J-Bracket

Low mode cage plates

Wrap grip

Thermodyne flight case (worn foam, but usable)

J box and J box to base extension cable

Compact vehicle mount kit

Manual including schematics and parts list

Original battery base assembly and monitor arm

Box o’ III spare electronics

The sled is in great shape and solid, gimbal is smooth and pans flat. There’s worn anodizing where the wrap grip clamps. Fore and aft adjustment on the top stage and base.

The original base shows little wear. The monitor is very bright and sharp, and the horizon works great.

The second base is gutted (sorry, Terry) and wired for 12v parallel. I left a wire to run 24v to pin 3 on the J-box if you want to do that.

The battery module is two diode and 10A breaker switch protected AB mounts and solidly mounts to either base.

Total weight with gutted base, monitor and no batteries (as pictured) is about 12 lbs

It comes with the compact vehicle mount kit that seems unused. The assembly instructions were still inside one of the tubes!

Not sure if the monitor arm is a PRO, maybe an old version. It does flip for low mode the same: with two registration pins to keep it solid.

A great starter sled or backup / big rig sled.

You are welcome to try it out in the LA area, but if you aren’t around 6’5 and 200 lbs, you’ll need to bring a vest.

$2,500

post-491-0-68315900-1468708356_thumb.jpg

post-491-0-84956500-1468708378_thumb.jpg

post-491-0-64558400-1468708385_thumb.jpg

  • Upvote 1
Link to comment
Share on other sites

  • 2 months later...
  • 1 month later...
  • 1 month later...
×
×
  • Create New...