Jump to content
John Dewberry

Fried HDMI Port

Recommended Posts

I could use some electronic guidance here. I have an a7s ii and monitor both powered from dummy batteries going to an AB multi tap connected to a v-mount battery. The hdmi port stopped working on both the camera and monitor and I can't figure out what caused the issue. I'm starting to suspect that the micro to full size hdmi pigtail I was using is the cause, but I'm not positive.

 

Excuse the truly terrible photo.

 

Is there something I can do electronically to prevent this from happening again?

Edited by John Dewberry

Share this post


Link to post
Share on other sites

I added a photo but it didn't show up for some reason.

 

I'll try to be more clear.

 

Power Distribution:

V-Mount Battery -> Anton Bauer PTap Multi -->

--> NP-FW50 Regulated Dummy Battery -> a7s ii

--> LP-E6 Regulated Dummy Battery -> SHD 502

 

Video:

a7s ii --> Micro HDMI to Full Pigtail --> Full HDMI to Full --> SHD 502

 

 

Somehow the HDMI port on both my camera and monitor got shorted out so neither one of them work. I had to send them both in for service. The problem is I can't figure out what on earth I did to cause it. I was on a shoot where it was working and suddenly it stopped. I tried replacing the hdmi cable and pigtail but the damage had already been done.

 

Any guesses what I did to cause the short?

Any solutions that I can do to prevent it?

Could the same issue have happened if the camera and monitor were using local batteries?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×