Volt calibration issue

[John atkinson]

I just put the volt on my MK-V Gensis 1.5" goofy foot.  When I zero balance, dynamic balance and calibrate, everything is fine.  When I turn on the motors the sled rolls over.  I saw this posted here before but I can't recall the solution.  I am calibrating with camera facing gimbal handle for Goofy.

 

Thank you!

[Kevin Jacobsen]

It sounds like when you are turning the volt on you didn't do so with the gimbal in the correct position. The gimbal handle needs to be oriented in a specific way when the volt powers up. I believe with goofy set ups the gimbal handle should be in line with the front of the camera as opposed to being in line with the rear of the camera for regular operating.

 

If this is not the case please feel free to DM me as I have a long list of troubleshooting techniques.

[Cedric Autier]

Hello John,

Have you tried to press the internal FLIP button inside the Volt? If your Volt is mounted on the right it should have been pressed during installation but worth a try.

Procedure is on page 37 of the Volt manual.

[John atkinson]

15 hours ago, Cedric Autier said:

Hello John,

Have you tried to press the internal FLIP button inside the Volt? If your Volt is mounted on the right it should have been pressed during installation but worth a try.

Procedure is on page 37 of the Volt manual.

That was it.  Thank you!

 

 

[Kevin Jacobsen]

woooo!