Jump to content

Zephyr - Bad SDI connection


Jacob Gosch

Recommended Posts

Hello fellow operators!

I have owned a zephyr for about 1,5 years now and yesterday when I was on set, I noticed a bad connection to the monitor and I narrowed it down to the connection at the top stage, I was getting a picture to the monitor sometimes and I could do a full shot, but if I touched the cable right at the connection or if I docked the steadicam too hard, it would loose signal.

is it possible to take apart the steadicam and see if there's something wrong or should I send to repair? Anyone experienced the same?

Hope you guys can help!

all the best - Jacob

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...