nick franco

SOLD

Sent from my iPhone using Tapatalk

$3000 or best offer.

Located in Los Angeles

Preston MDR-2 G4 Blue dot

PRO dovetail mount

FilmFrog cheese plate

Preston serial cable with USB adaptor

command cable

Cine Tape interface cable

Pana Tape interface cable

PRO- MDR power cable

2x 3 pin -MDR 4521 run

Sony F5/F55 run

2xSony 4435 run

2x Ari 11 pin Fischer run 4520

Red run 4543

2x Panavision run cable 4522

AATON run4524

2x Movicam 2 pin run cable 4523

3 pin to MRD power cable

Pana to MDR power cable 4472

Anton Bauer Ptap to MDR power 4473

Like this?

http://xcsinc.com/#

Motor is sold.

I've been expecting you.

DM-1 with Hill rosette, just checked out by Preston.

In Los Angeles.

The clamp needs to stay on the top, otherwise you're not getting the benefit of the bearings.

The inner race of the upper bearing sits slightly higher so the clamp can ride on it.

My feet are 10.5 EE, New Balance 990 has been my work shoe.

Also, http://www.wihatools.com

He paid for it by only filling the Hummer half way.

Does it have cap screws on the face plate? Might be able to open it that way, but that would be wrong.

Pull the canisters and clean the two pins and their mating surfaces on the chassis.

Not sure what vest you have but I had a similar noise that turned out to be where the plate that holds socket block meet the center upright spar. Took it all apart, cleaned it and reassembled it, no more noise. Pro vest.

Try Robert Luna , he might be able to make an adaptor post?

For post size?

Nicely done!

I remember that one. Was demoing for CP at that show. High-tailed in my car back to Boston well after most sane people considered the city shut down, like the wiseass I was.

 

Was?

I'll make you an indecent offer.

Good piece of kit.

With cinelock.

C harles went and broke another operator!

Well it's just like a movi...

And I thank you.

This is also a good product for finishing off small areas of small raw steel.

http://www.brownells.com/gunsmith-tools-supplies/metal-prep-coloring/metal-bluing/liquid-cold-bluing-chemicals/oxpho-blue--prod1072.aspx

Yes, that is the current model. However they replace the analog-type pots with a different kind of pot. I can try to post a picture on Monday when I'm back at work, but basically imagine a dial that goes from 1 to 10.

Not 11?