Jump to content

Benjamin Treplin

Sustaining Members
  • Content Count

  • Joined

  • Last visited

  • Days Won


Benjamin Treplin last won the day on April 7 2017

Benjamin Treplin had the most liked content!

Community Reputation

19 Good

About Benjamin Treplin

  • Rank
    Advanced Member
  • Birthday September 10

Profile Information

  • Rig
    a broomstick with a gimbal
  • Location
    Berlin - Germany

Contact Methods

  • Website
  • ICQ

Recent Profile Visitors

4653 profile views
  1. Some browsers or their settings force https for security reasons. You website only supports http.
  2. Looking for a DUAL 2722 charger. please PM me.
  3. I own s/n 15 still with the Steve St. John's tag. Bought in 2007 from Gregory Smith. Frankensteind it to my XCS with a PRO donkey box 1 bought from Alec. Hope you'll find one Roman!
  4. I had similar issues with regular Alexas and REDs in combination with my Ultimate 1 electronics. 12 vdc was hard wired, so always power on the camera. The moment I switched the Ultimate 1 electronics on (28vdc inverter and some minor bits and pieces) the camera did a reboot. Probably it takes only a few milliseconds of a voltage drop to cause an off/on at the camera.
  5. Looking for GPI PRO gyro mount. The whole assembly that goes onto a gyro. Best, Benjamin
  6. Hi Alastair, what version of a PRO rig do you have? Did you on/off switch any other devices on your rig that was in sync with the LF turning off? Did it turn off or did it reboot? Preston in the mix? Powered over the rig or camera?
  7. Depending on the XCS plates you have (there are a few variations) they might not fit the M1. The dovetail face might not be high enough. It depends on how wide the vertical part of the plate is.
  8. Selling two (2) used XCS sliding camera plates. €250 each. These plates are $625 new. Only shipping to Europe! VAT Nr. is required for EU buyer! 19% VAT for German buyer! Buyer pays shipping!
  9. Selling a bunch of used XCS plates. 3 in mint condition €180. 2 in good condition with cosmetic wear €150. These plates are $400 new. Only shipping to Europe! VAT Nr. is required for EU buyer! 19% VAT for German buyer! Buyer pays shipping!
  10. https://www.dropbox.com/s/32yaasjpdbiihy7/Transport-DIONIC%20HC.pdf?dl=1 It's just the relevant page of the user manual. You'll find that on the Antonbauer website.
  11. Looking for an old thin XCS camera plate Greg Bubb used to have in the early 2000s.
  12. Thanks AJ! Doing a movie with Daniel Radcliffe at the momentan. For some shots we attached an iPhone to him. Got great results with smoothing between 10 and 15. Sometimes we went as far down as 6. There is quite a gap between 6 and 5. 5 is unusable whereas 6 works for certain shots.
  13. Hi Ramon, Jens, I would love to see a few pictures of your solutions. Ben
  • Create New...