James Poremba
-
Posts
2 -
Joined
-
Last visited
Posts posted by James Poremba
-
-
Any assistance would be appreciated to get me started.1) Should I replace my two pin LEMO with a more modern three pin for power? Not sure if "more modern" is the correct term, it just seems to be in wider use.Hello, I purchased a used Steadicam flyer
(first gen I believe, grey arm?) and knew that the power cables from the
battery plates to the LEMO connector (2-pin) was severed. My plan is to
replace the cable harness to allow me to hook a LEMO to D-tap then a
D-tap splitter box to hook up to a RED scarlet / monitor / bartek etc...
I have a couple questions:2)How do I go about wiring both Anton Bauer battery mounts that were
included on the sled to run up to that LEMO connector? I would like to
be able to use 2 batteries on the bottom running together up the post to
the power port. I'm not sure where to start on this, or if that is even
an option (see included photos)Thank you
Power Options for Flyer 1st Gen.
in Sled
Posted
Thanks for the feedback! I have a couple more questions about power then, should I request this be moved to the battery/power page?
I really would like to know how to run both battery mounts in series up to the lemo connector. I think running it to a lemo breakout box is a great idea, but I'm not sure how to run cables from both battery mounts to one main lemo connector (which will then break out) There are two wires (hot a neutral/ground I assume) from each mount, so to run them to one lemo connector...not really sure where to start.
Thanks in advance for any further assistance
James