Jump to content

Gareth Manwaring

Premium Members
  • Posts

    37
  • Joined

  • Last visited

Everything posted by Gareth Manwaring

  1. Hey Steadicam Fam! I have a Micro Force V+F2 for sale if anyone is interested. I’m not quite sure what this would go for so best offer goes. -Gareth
  2. Hello Steadicam peeps. I’m looking to off load some batteries for some lower wattage ones. I purchased half of them in 2021 and the other half in 2022 you can see by the cycles count which is which. Brand new they go for a little under $500 I was going to start at $350/battery and see is that works for someone. $2,800/8 batteries OBO buyer pays shipping. Also note that some or all of the batteries might be out of warranty and Anton Bauer suggests keeping the batteries charged at all times for best results. -Gareth
  3. Hello Steadicam Peeps. Pics and inventory below. looking for $13,000 or $6,500/kit. Buyer pays shipping. -Gareth Bolt 4K breakdown.pdf
  4. Hello Steadicam peeps! I was wondering if anyone can share their average battery life that they have gotten before a battery has stopped working compleatly? Brand and years worked would be great. -Gareth
  5. Close ups of single channel below.
  6. Hey Lane, I’m pretty sure it’s has the antenna attachment at the top. (I can get a pic for you later) but what switch? And where would that be located? -Gareth
  7. I have a complete Preston kit for sale. Looking for $25,000 OBO inventory and pictures below. Buyer pays shipping unless they would like to pickup in Brooklyn, ny. -Gareth Preston For Sale.pdf
  8. I have these two items for sale. If interested please make a offer. Buyer pays shipping. Located in NYC.
  9. I have moved on from this monitor to something that’s brighter but this one still works great with no scratches. I was using it in my Quattro II yoke on my pro. So if somehow that works for you the cables and kit are included. Tvlogic LVM-075A s/n LV075AP0228 8pin RS to tvlogic 36” 8pin RS to tvlogic 24” Plastic hood Quattro II Mounting kit - TV Logic LVM-074W (two knobs in the picture you will need to have the QUATTRO II postclamp rods and yoke that match which are not included) Asking $1,250 OBO buyer pays shipping.
  10. I have a well maintained cinetape located here in NYC for sale. Asking $5000 OBO. Buyer pays shipping. 1x Cinetape Readout S/n 30546 1x Cinetape Horns s/n 35625 2x Cinetape sensor cable 1x 3pin RS to 3 pin RS cable 2x 3pin lemo to 3pin RS cable 1x 1200 Pelican Carrying Case 1x backup knob
  11. Hello Team, Does anyone have a low mode bracket, f-bracket or similar for the G70x? Also does anyone have a 12” riser for the G70x? Thanks. -Gareth
  12. Koji, I recently tried to send in my pro gimbal to tiffen to have the Volt attached and tiffen was unable to make it work. Tyson at Tiffen suggested I get the whole Volt setup instead of trying to convert my pro gimbal over. They sent me the whole Volt kit with a disclaimer that it might not fit perfectly and I might possibly need to send in my sled post to have it fitted. In the end the step down rings they sent with the Volt fit great. Now I just keep my pro gimbal as a backup. -Gareth
×
×
  • Create New...