Pedro Silva

I had to use Nucleos -M and there were several connection problems between the focus motor and the hand unit. It was very bad, because the focus assistant was forced to calibrate the system several times, which is embarrassing because it forced some stops. Within this range of equipment the DJI follow focus system works much better. Otherwise, if possible, bartech or similar. Pedro

Thanks Louis! I'll check itt!! Pedro

zoom controller Hello everyone. I want to buy a new zoom controller. bebob zoe is no longer produced. Which zoom controller do you advise for live broadcasting? Thanks Pedro Silva

Hi, everyone! I recently found some vibration on my efp top stage. I think it comes from the front five screws that belong to the clamp edge. All the screws seem to be very tight and i'm afraid that they broke if I try harder. How could I solve this issue? Do I have to take the top stage off the post to solve that? Thanks Pedro

Hi everyone! How can I get the user manual of an old Seitz follow focus? Thanks Pedro

Hi Aline! Can you mail me with photos? Thanks! ped.melo.silva@gmail.com

WTB analog Bartech handset and reciever. No need motors! Pedro Silva

WtB steadicam steadimate adapter! Cheers

Hello everyone, Someone knows the pinouts configuration of the Hirose, Lemo and XLR connectors of the Jbox and Dbox of the EFP sled? Where can I access this information? I need to make some cables. Thank you, Pedro

Search for an Arri Artemis Vest. Europe. Thank you!

Hi everyone! Does anyone have tried the Smartsystem´s "Smartcam Vest Lite"? Any opinions? The best, Pedro

Hi everyone! I want to buy a Provid ou SK2 steadicam. Please email me. ped.melo.silvagmail.com

Olá Tiago, Desculpa só responder agora, mas como não recebi notificação do teu post.... A forma como passas o cabo é igual à forma como faço. :-) queria era ver se havia outra forma. Sou op da Rtp Porto. E tu? Abraço

Hi Maurizio. Thank you. I'll go to your website then I send you a message. All the best. Pedro

Hello everyone! Does anyone knows where can I get my IIIA arm tuned and machined here in Europe? Thank you Cheers, Pedro