Jump to content

Devindra Sooknanan

  • Posts

  • Joined

  • Last visited


1 Neutral

Profile Information

  • Rig
    non yet
  • Location
    oakland california

Recent Profile Visitors

250 profile views
  1. Hey Beau, I know this is an old post but do you recall how you centered the gimbal bearing on the x45? I have a v25 and I assume it's similar but I'm not sure how to do it in general. Any help would be appreciated. Thanks Devindra s.
  2. i also got some cam lever 1/4-20 quick release handles i added pictures to the google drive makes the monitor arm lock better to the post and allows me to adjust stuff faster
  3. Hey Raphael, I had the same problem but i found a bit a a solution, i added a v mount battery plate to the bottom of the rig. I got a the V-mount battery plate off ebay, 4x 1inch long 3/4 hex standoffs with 10-32 thread https://www.google.com/search?q=3/4+hex+standoff+10-32&hl=en&sxsrf=ALeKk02kKi5hQncBdED9YdAw5PO8CVuGHw:1586332693498&source=lnms&tbm=isch&sa=X&ved=2ahUKEwiLysPlrdjoAhVRFTQIHZYzBSkQ_AUoAnoECAwQBA&biw=2133&bih=1076 4x 5/16 diameter 1/2in long spacers https://www.google.com/search?q=5%2F16+diameter+1%2F2inch+long+spacers &tbm=isch&ved=2ahUKEwisqNuortjoAhXyJn0KHVB0CboQ2-cCegQIABAA&oq=5%2F16+diameter+1%2F2inch+long+spacers &gs_lcp=CgNpbWcQA1Dz9wJYqJoDYPSfA2gAcAB4AIABVYgB_AGSAQEzmAEAoAEBqgELZ3dzLXdpei1pbWc&sclient=img&ei=ooSNXqzPF_LN9APQ6KXQCw&bih=1076&biw=2133&hl=en some 1inch long 10-32 cap screws and washers. flip the rig over, take the thumb screws holding the sliding base on and replace them with the hex standoffs, then put the screws through the battery plate, put the washers and spacers on them screw the plate to the hex stand off. here's a good drive link to see how mine turned out https://drive.google.com/open?id=1D8bmIu9Au_9dPFGV0VJl1jBr6KSE23_0 let me know if you have any questions. I got all the hardware stuff from a small hardware store, home depot didn't have it but a neighborhood ACE or smaller hardware store might. good luck yo Devindra S.
  4. Hi Ken, did you just splice the a diode into both positive wires?
  • Create New...