Jump to content


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral


  • Rank
    New Member

Profile Information

  • Rig
    Flyer LT
  1. That is exactly what I was going to do with 15mm rods xD Did you find it made the rig better than before? I am pretty new to Steadicam (as in actually learning the thing properly). The limited stock bottom stage is just not working for me atm so was looking into doing this (pretty much exact) mod. Thanks Jack,
  2. Hi all Thinking about modding this Flyer LE I have. I am happy using the Flyer (I only use it for personal projects, I am not really a Steadicam Op, pretty much learning still) but the fine tuning is a bit difficult due to the lack of movement the monitor and battery have. I was wondering if a split shaft collar would work well to camp to the bottom post (the internal one) to replace the current mount and stage down there with a custom one I am machining. Going off these photos, it looks to work fine. Any advice for doing this? Thanks Jack,
  3. Tested out the LINK-MI system. Managed to get the same thing but re-branded on Amazon (was £300 but Warehouse discount + student discount meant it was £170). Pretty good. About 1/10 second delay. Range is pretty decent too when positioned well. It is not ultra low delay like the Bolt but it is 1/10 of the price which works for me :p
  4. Still has 1/4-1/2 second delay? Hmmm I already use my Ubnt AP to get better signal, without it, get loads of crap on the screen even within a normal room with only few people in it.. The Bolt is pretty good (would be awesome if the last few times we had it on set it didn't stop working half way through :p). PS, this is for my personal kit, if it was proper set we always rent decent setup.
  5. I know it is not Bolt quality but that is when paired with iPads and other devices. The Clip decoder might actually be decent enough for it...? I have connected the Clip to my PC and displayed it on full screen and it is possible to do it though it is a tad soft is all.
  6. Hi all. So currently I have a Teredek Clip TX. Just about to invest into a cheap wireless follow focus so need to finish up my wireless setup. I can either buy the Clip RX, which I have not used before, seen anyone else use it or any review... Or go for a cheap TX/RX "HDMI wireless transmitter". Like the ones you see on AliExpress for $200. Such as this one from LINK-MI https://www.aliexpress.com/item/LINK-MI-LM-WHD05-50m-5GHz-WHDI-802-11n-Wireless-HDMI-Wireless-Video-Transmitter-and-Receiver/32374563588.html?spm=2114.01010208.3.2.f3m8Dg&ws_ab_test=searchweb0_0,searchw
  • Create New...