Ken Nguyen

I learned this from my mentor. This is a very effective technique to mimic handheld shot. The result shot is much better and smoother. Cheers, Ken Nguyen.

There are 2 composite video signals cable inside the post with connectors. They are good enough for HDSDI signal. Just disconnect them to signal processing and splitter. Connect both ends to BNC connectors then you have 2 HDSDI connections. Here is how; Keep all the connections from stage-to-post and post-to-bottom-electronics. Inside the nose, keep the one that connect to BNC. Disconnect the other cable that connect to the 4-pins Hirose, cut off the signal splitting cable to the back-stage 4-pin Hirose. Drill a hole on the side of the nose for a second BNC, then solder the video cable to that BNC. Remove the cable which connected to the 4-pin in the bottom electronics. Cut off all connections to composite signal processing. Build a new BNC, then solder that cable ends to. DONE. you have 2 separated solid direct HDSDI connections. Mines are fine with 3G-SDIHD Have fun, Ken Nguyen.

Make sure you have a 12V regulated source to power Blackmagic converter. The D tap might not work. Cheers, Ken Nguyen.

Wow! interesting device! What is the benefit of this over the use of longer arm post? Just based on the definition from XCS website, it displaces the camera higher and lower just likes the way we use with the arm post. Greg, can you give us more detail of its use and benefit? Cheers, Ken Nguyen.

Thank you for sharing. I have a VHS copy of this from Ted, but it is water damaged. Ken Nguyen.

Looks cool! I went to the booth, but I didn't see this one. I saw the "toy-like" baby-blue color batteries, which turned me off. Good work! Ken Nguyen.

Hi Rick, I'm about 2hrs of drive to your location. If you have a runner, you can borrow mine. Cheers, Ken Nguyen. 714-465-7405

I used "ideal diode" Try this: http://www.re-voltage.eu/electronicsID80V2.html Cheers, Ken Nguyen.

Bring along a portable propane heater. Stay warm, Ken Nguyen.

Sold. Thanks,

I think so. That's sad.

Toaster oven may not work because it is not vented. Use oven 300F for 3hrs. Cheers, Ken Nguyen.

BTT

SOLD. Thanks, Ken Nguyen.

SOLD. Thanks,

Hi Brooks, I've been working with mac and FCP since its first edition. I think I can help. Most likely is the codec of the ripped files is not compatible. Email me how did you rip the dvd in details. Cheers, Ken Nguyen. PS: Just helping forum member. No charge.

2 Used, but very well kept PAG AR-304 NiCad Charger, $175USD + shipping each. Paypal is welcome. I'm in California. Thanks, Ken Nguyen. kennguyen@mac.com

Used PRO Low Mode Bracket with 4" post, $140USD + shipping. Paypal is welcome. I'm in California. Thanks, Ken Nguyen. kennguyen@mac.com

Used original PRO DB-II T-Bracket, $140USD + shipping. Paypal is welcome. I'm in California. Thanks, Ken Nguyen. kennguyen@mac.com

PRO Docking Bracket, used, $350.00 + shipping. Fits 1.5" post. Paypal is welcome. Thanks, Ken Nguyen. kennguyen@mac.com

SOLD. Thank you, Ken Nguyen.

SOLD! Thanks, Ken Nguyen.

All plates were SOLD. Thanks for all of those who interests. Ken Nguyen.

SOLD. Thanks, Ken Nguyen.

More pix: