-
Posts
30 -
Joined
-
Last visited
Posts posted by Jake Bulgarino
-
-
Bump, currently still available.
-
Tiffen Steadicam Archer 2 SYSTEM w/G50X Arm and LX Vest - Location: Los Angeles - Venice, CA - $19,500Purchased 12/2011Archer 2 - SN#0212001SG50x - SN#G50X1211008AJust came back from TIFFEN for a QC and all electrical and balance is in fine working order. I will provide paperwork from service. The rig has been well taken care of and as you can see from the pictures it's in great shape.-Sled: Archer 2 sled with dovetail plate, IDX VMount (No batteries or Charger Included). 7" 16x9 MARSHALL Monitor. 12V or 24V DC output. Non-Motorized tilting stage.-LX Vest: pads dry cleaned, just came back from Tiffen fully checked out.-G50x arm - With 15lb sled ( 2x battery weight included), payload approximately 35lbs. Just came back from Tiffen fully checked out.-Archer 2 docking bracket-(1) Hex Wrench Included 1/4"-Thermodyne Case (all items fit in case)-Steadicam SteadiStand C-StandAccessories-Archer2 Low Mode bracket ("F" Bracket) - to keep arm from whacking camera when operating in low-modeMost of my cables have been sold, but I have these.Monitor Cable - (Tiffen Part Number 800-0111) 8 Pin to BNC / 4PIN XLRF3 Pin Lemo to 4 Pin XLRF (12V Power)3’ BNC Cable2’ BNC Cable2 x Battery Weights Included1 x G50x Carry Bag1 x Steadistand w/ Bag$19,500If Interested, PM Me at jake@eastward.com
-
Hey everyone,
I have a pretty new Archer 2 rig and every once in a while the monitor starts acting up. .
I attached a picture so you can see what it looks like. Has this happen to anyone else out there?
The only way I have been able to fix it is to turn the monitor off and back on and it is gone for awhile.
Should I send this back to tiffen?
Best,
Jake
One of my Marshall monitors was doing that, it was the processor. It needed to be replaced.
JA
Yea I figured it wasn't good. Where did you send it for repair?
-
I'm about to start a long job with the Archer2 as well that belongs to the client, Here's hoping its an isolated problem. The sled Ill be using has the same Marshall monitor.
Ozzie
Good luck, you should be fine. The Archer 2 up to this point has been a pretty solid rig for me. Never been a huge fan of the monitor though. To make it worst my Dovetail Locking plate (today) is not locking a camera down that is well within its weight range.
Iv tried to tighten down the screw and adjust it but it is not helping. I have a pretty long shoot coming up in october so I gotta move fast.
-
Looks like the Matrix in the movie...Can you speak to the oracle?
But seriously, Call Tiffen and let them know.
haha, seriously. Yep I am going to email Peter today. Thanks.
-
-
Hey everyone,
I have a pretty new Archer 2 rig and every once in a while the monitor starts acting up. .
I attached a picture so you can see what it looks like. Has this happen to anyone else out there?
The only way I have been able to fix it is to turn the monitor off and back on and it is gone for awhile.
Should I send this back to tiffen?
Best,
Jake
-
So when is a big rig workshop coming to DC?
I second that!!!
-
5600k not 3200k :-)
-
Great Work!
-
Janice Arthur's plates/cages are great! Just got a cage for my Archer 2 and couldn't recommend them more.
-Jake
-
Hey Chip,
Any idea where you got the case?
Best,
Jake
-
Very cool! Thanks for sharing.
-
Hello,
I am looking to purchase the follow items, please feel free to email me if your interested in selling.
Archer 2 (No vest)
G-50 Arm
Bartech FF
Weight Plates
Thanks,
Jake Bulgarino
jake.bulgarino@gmail.com
www.facebook.com/eastwardfilms
www.vimeo.com/eastwardfilms
-
Wow, what a bummer.
Just from my own personal use with the zephyr and working with one at a workshop, I noticed as time goes on the clamp doesn't have a ton of durability and can become kinda finicky.
-
Hi Jake, all,
To avoid confusion......
All Archer 2 systems come with the G-50.
Archer 2 manual stage
Archer 2S stage motorised in fore and aft axis only
Archer 2SE stage motorised in both directions, leather vest, 2 batteries and a charger
Stage remote motors can be added later so at this stage you could use that money towards the HD monitor.
Robin
Hey Robin,
Thanks for the clarity.
Best,
Jake
-
Hi Jake
The Archer 2 will come with a 6" Transvideo Superbright now rather than the HD UltraBrite. Makes a nice match physically.
Robin
Hey Robin,
Thanks for the update.
Is the 6" Transvideo Superbright monitor the one that comes with the cheaper archer package? If not, which one comes with the cheaper one and does it have a horizon meter?
Best,
Jake
-
I operate with an Archer 2 and have it with the SD monitor. When I purchased a year ago I decided against HD because I needed that extra money for others things like batteries and cables. I use a downconverter with it and haven't had any problems. The wiring in the post is HD ready, so if you go the SD monitor route you can upgrade one day with no problems.
Hey Aaron,
Thanks for your response. Do you know if the SD monitor comes with a horizon indicator? What downconverter have you been using? What cables should I be planning on buying? Most of my work will be with the F3 , FS100, Red, and Epic.
Thanks for all your help.
-
The motorized stage is very handy, but you don't need it.
I use mine to balance the sled, holding the remote in one hand, and a cup of coffee in the other :) And sometimes i use the memory buttons, while shooting, to trim the balance if i for example need to shoot downwards and back again to normal. But you could just change the drop time to neutral and the sled is just as easy to operate.
If the A2 comes with a G50 arm now, I would go for that.
Later you can upgrade the monitor and the batts are less expencive to buy another place.
Hey Thomas,
Yea that sounds pretty awesome but I definitely need to cut costs where I can. I think out the gate I am going to have to go with the the Standard Def monitor. Working with beer money here.
Where is a good place to look for upgrading my monitor a little down the line.
-
Hey Everyone. I have been operating a Pilot for sometime now and am in the market to pick up a bigger rig and get serious about operating.
I am pretty certain I am going to go with the Archer 2. I am looking at the pricing and see a big difference in pricing depending on what monitor I get.
There is about a $6000 difference between getting 7"STD def 700 monitor and an HD Ultrabrite 2 Monitor. They have a middle of the road HI-def monitor that falls right in the middle price wise.
That being said I was curious on your guys take on the monitors and what I should be taking into consideration in when purchasing. Any ops located in the MD DC Area?
Thanks for your time!
-Jake
Also if I ever wanted to upgrade the monitor later would it be difficult considering the wiring in the sled?
-
http://www.steadicam...ison_chart.html
Looks like the main difference is the motorized stage option.
The differences are
Archer 2 comes with the G-40 arm, and there are only few aks in the kit.
A2S and A2SE are almost identical.
G-50 arm, Motorized stage (S= fore/aft) (SE= side-side and fore/aft)
Lowmode kit
Stand
Archer 2SE also got:
Leather LX vest
Power Cubes IDX, and Charger
Thomas :-)
Hey thanks for your responses. According to tiffen all the Archers now come with the G-50 Arm. I dont think I am going to get a motortized stage. The extra cost is pretty significant. Does anyone have any experience using the motorized stage and see why is could be really handy?
-
Hey Everyone,
I am in the process of purchasing a New rig and have been looking at the archer.
I notice there is 3 different models; Archer 2, Archer 2 SE, & Archer 2s.
What are the major differences between all these models? The price varies greatly between them. Thanks for your time and is anyone Located in the DC / MD area?
-Jake
-
Hey Everyone. I have been operating a Pilot for sometime now and am in the market to pick up a bigger rig and get serious about operating.
I am pretty certain I am going to go with the Archer 2. I am looking at the pricing and see a big difference in pricing depending on what monitor I get.
There is about a $6000 difference between getting 7"STD def 700 monitor and an HD Ultrabrite 2 Monitor. They have a middle of the road HI-def monitor that falls right in the middle price wise.
That being said I was curious on your guys take on the monitors and what I should be taking into consideration in when purchasing. Any ops located in the MD DC Area?
Thanks for your time!
-Jake
-
Hello All,
I am a new owner of a Steadicam Pilot. I have been trying to get dynamic balance with my canon 7D and I get close but still can't nail it. Static Balance is super easy but dynamic is another story.
Does anyone have any quick tips for achieving dynamic balance?
Should I spend more time on trying to achieve dynamic balance instead of flying the rig?
Any seasoned steadicam ops have experience Flying DSLR's?
Thanks for all your input!
Jake
Archer 2 w/G50x System for sale - Great Condition
in Steadicam Marketplace - For Sale
Posted
Thanks everyone for the replies. The rig has been SOLD.