Hey team,
So I got clipped by a wheelchair rugby player, went down rather hard, seemed to be fine. The only thing I broke was the monitor yoke that Frederic Sturm makes. He sent me a new one so was all good to go. Now I haven't touched the rig for a while and puled it out on Friday in prep for a job and find that the sled can not be balanced no matter how hard I try.
The problem:
I static balance, rotate 180 degrees & I am vastly out of balance. If I balance up again, rotate 180 again, I am back out of balance by a lot. Also the sled will spin to find its lowest cog.
Model:
Steadicam Zephyr with the extra bits Frederic Stum wonderfully makes.
I am guessing it has something to do with the gimbal. That said, it is rather perplexing as to what would cause this. Any one have any ideas? Is this something I can try to adjust on my own?
I am most likely going to send it in to get looked at unless someone has direct experience that I can reasonably follow.
Thanks peeps in advance.
Nat J