Jump to content

Search the Community

Showing results for tags 'Mod'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Steadicam Forums
    • General Discussion
    • News, Events, Workshops
    • Steadicam Marketplace - For Sale
    • Steadicam Marketplace - Wanted
    • Steadi-Newbies
    • Journals
    • Great Steadicam Shots
    • Operating
    • 3D Steadicam
    • Steadicam Aesthetics
    • Sled
    • Camera Stage/Donkey Box
    • Center Post
    • Gimbal
    • Arms
    • Vests
    • Wave/Volt
    • Monitors
    • Batteries/Power
    • Follow Focus
    • Cases/Carts/Stands and Transport
    • Brackets/Widgets
    • Vehicles and Mounts
    • Other Stabilizers
    • Cameras (Film/Video/HD)
    • Video Assist and Video Accessories
    • Industry Contacts, Info and Links
    • Legal / Business Practices
    • Picture and History Archives
    • Off Topic
    • Forum Support

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


Location


Rig

Found 3 results

  1. If I have a master series post can I remove/cut off the bottom electronics and clamp on or add-on a new bottom with new electronics? To upgrade it to HD. Along with new top box. Or is there an easier way to do this.
  2. Hello guys, I decided to make a little mod on my Ultra2 and before I go ahead I’d like to have some input from U2 owners. I want to get rid of the upper monitor mount on the post3 in order to be able compress the rig another 3 inches or so. Since I bought my rig last June I never used the upper mount. In normal use, I place the monitor as down as possible. Even when I setup the rig to the extreme high or low mode the upper mount never seemed useful to me as it places the monitor too up high to my taste. But when I fly lighter loads like an epic, not being able to shorten the rig another 3 inches translates to either less space to move the gimbal down on post2–harder to go to low mode- or too much space above it. Also when I put a codex or OBI-1 deck at the base of the sled while shooting Alexa/Raw setups, the up-down weight ratio forces me to collapse the rig fully and every inch counts! Even if an unpredicted situation presents itself, I can have another 15cm or so to raise the monitor by placing the monitor rods in reverse. In order to take the mount out I have to undo the wires in the stage which is not an everyday job. That’s why I’d like to hear your input on the subject. Do you use the upper mount? In which situations?
  3. is there such a device where you can continue to keep your Rig powered when docked for an extended period of time, during lunch hour, coffee breaks, etc. so I could dock and plug my rig into a standard 12VDC power supply, and walk away for a bit without losing sync to my wireless transmitter, or not having to powering down the camera, or pull the battery out, etc. especially for single battery rigs... (i presume with the big rigs you can easily hot swap batteries since they use more than 1 battery.)
×
×
  • Create New...