Search the Community
Showing results for tags 'Red Spring'.
-
Hugo has spent quite some time getting these right. They should fit any and every cinema products 3A style arm, no matter what serial number (apparently there were slight differences over the years). Refreshed look of a classic arm that will never go out of style. It's no PRO, but anyone who's owned one of these will surely agree, it's rock solid and always dependable. Now given a refreshed look, and for me, quicker access for user repairs (I have the toolless attachments made by Robert Luna, which now I no longer have to remove to get the spring covers off), and the spring tension window is longer for ballparking the weight. Give Hugo a shout if you need to replace your arm covers. admin@steadyrig.com
-
I am selling my backup arm. It is an EFP red spring arm in very nice condition. This arm has a lift capacity of 16-40 pounds. Here is the list of maintenance that has been done to it: - The arm covers have had a couple small dents straightened and they have been powder coated. - The rubber bumpers on the center joint are brand new. - The screws that hold the arm covers and bearing pins have all been replaced with black oxide coated stainless steel screws for low maintenance. - The tension screws have been replaced and the new ones are slightly longer than stock so the arm can be tuned a little lower than the stock configuration and it is easier to disassemble the arm for cleaning. - The spring stops have been upgraded to 4-40 set screws (The originals were the older style dowel pins that were very hard to remove if you wanted to clean the arm) Asking $4,300