Search the Community
Showing results for tags 'zalex'.
Selling my Archer 1 SE sled, 7” TV Logic monitor & extras. The sled is in good condition, I’m the second owner. Gimbal works perfectly. Sled converted to V lock by Optical Support and has an HD-SDI line. SE model has a tilting top stage. TV Logic 7” LVM071W with mounting screws. Monitor is in well-used condition but still works fine. There’s a very thin line across the screen when on (never been an issue for me). Other extras included is a Tiffen low mode bracket and Zalex longplate with hardware. Included - Archer 1 SE sled - Docking bracket - Archer dovetail plate - Zalex longplate with hardware - TV Logic LVM071W 7” monitor (with mounting screws & washers). It has a very thin line across the screen when on. - 1 x camera power cable (lemo – 4 pin XLR) - 1 x short BNC - 1 x flyweight BNC - 5/32 T handle allen key - Tiffen low mode bracket - Transvideo Titan TX & RX + cables (never used it, came with it when I bought the kit. Might be useful to someone.) - Archer 1 Manual £3800 ono Based in Bristol, UK. Can post at buyers cost.
Hello fellow Steadipeople! I once saw that Chris Fawcett has a longer plate for his Archer2 and asked him where he got it. Turns out he had it made by a local machinist. Then I saw that Peter Abrahm made the "Zalex Long Plate" and was amazed to find what I need. Unfortunately it's not meant for my dwarf top stage. (also an Archer2) Even though there is a way to use it on my stage I wanted a solution that really fits. So I decided to remember my classes on mechanical design and do one myself. Now my questions to you are: Does anybody else want something like this? Do you have suggestions or improvements to the original design? Status right now: Basic design complete. (Safety pins still missing) Lenght 42cm/16.5in Same hole pattern as the standard plate. (This plate should also fit Zephyr/Clipper/Aero?) https://www.facebook.com/groups/thesteadicamgroup/permalink/10154392148416629/
For sale Zalex Longplate This plate is BRAND NEW and never seen a day of work. Very minor single corner marking (as seen in pic) from sitting in a bin that got jostled around during a move. Other than that it is pristine. Peter does good work -this plate is a beauty but I have too much gear and letting it go. Comes with all hardware, printed instructions and I'll even throw in my micro-wrench. Good for tightening the bits and just general all around schtick. Paid $300 USD for it. Selling for $250 USD. Ships from Toronto, Canada. Buyer pays shipping. Please send inquiries to firstname.lastname@example.org