Premium Members Tommy Stork Posted November 7, 2014 Premium Members Report Share Posted November 7, 2014 What connector on the j-box did you have the cable made for? Quote Link to comment Share on other sites More sharing options...
Premium Members Stew Cantrell Posted November 7, 2014 Author Premium Members Report Share Posted November 7, 2014 I do have the sled set to 24v when I tried it. I'm going out of the 3 pin lemo on the upper junction box. There are two, and I've tried both. There are also two 3 pin outs on the bottom, which I have also tried. My monitor is receiving power from the sled, so i know that there is power from the bottom, and we tested the all the 3 pin outs while I was at GPI. Terry has made me 3 cables so far. Two have been exactly the same (12v) and this recent one was 12v/24v. I'm not sure if it is wired incorrectly or if I'm losing my mind. I sent him the wiring diagram that Preston sent me, so I figured it should be fine, although I'm not sure if he followed it or not. When I looked at the wiring of the cable, on the preston end (4 pin), #4 was not wired. Below is the diagram from Preston for the MDR1. Quote Link to comment Share on other sites More sharing options...
Premium Members Stew Cantrell Posted November 12, 2014 Author Premium Members Report Share Posted November 12, 2014 Issue has been resolved! Quote Link to comment Share on other sites More sharing options...
Premium Members Andre Trudel Posted March 6, 2015 Premium Members Report Share Posted March 6, 2015 Just out of curiosity, what fixed it? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.