Scorpio Remote Focus System

[Stewart Whelan]

Scorpio Remote focus system for sale.

Recently upgraded with new radio card and firmware Ver. 5.30

Every Bracket and cable configuration imaginable.

 

 

Hand unit

MDR

2 Preston antennas

3 Digital motors

5 Motor brackets

19 Focus rings

 

Panavision

4 Motor cables including right angle –green

1 Preston/Scorpio motor cable

2 x 10’ Pana cable XLR with Scorpio camera switcher (Lemo/Fisher)

2 Pana power (Large fitting) to 2 pin lemo cable (very short cable)

2 Pana command (on/off) driver cable

3x 3 pin Donkey box power (11/30vdc) to 24V Pana Lemo

 

1 Panavision focus gear

1 48 pitch gear (Panavision Zoom)

1 64 pitch gear (Panavision Iris)

Hex screws

Kip screws

 

12 Sony Lithium Hand unit batteries

2 Sony Lithium Hand unit battery charger with cable

3 Arri bushings (blue)

6 Panavision bushings (brass)

 

1x .89mm Allen key for scorpio motor

1 Panavision motor focus bracket -(slides into Front body focus mount)

1 Donkey box/shoe bracket -(slides onto lens light bracket)

1 Support rod motor bracket -(slides onto Pana zoom rod bracket)

1 silver 2 ½” 15mm rod

1 silver 3 ¼” 15mm rod

1 silver 4” 15mm with 3/8 – 16 threaded stud rod

2x 2” Blk female/female

1x 2” 90* offset female/female

 

 

Arri

2x 3 pin Fisher to Arri 3 pin R.S. power cable (on board 11/30 vdc) -yellow

1 Hand set to Donkey box cable “0” setting –red/white

2x 4 pin XLR to Donkey box power cable (11/30 vdc) –brown

1 Arri control cable BL-IV SRII Arri III

2 Arri 535/435/SR3 Command cables (camera run on/off) –blue

1 Handset power cable to 4 pin block battery

2 Scorpio power 12v

2 Arri run/stop

 

Digital Cameras

2 x RED Epic start/stop

2 x Sony F900/ F35 Start/Stop

 

Motion Generator

Includes:

o Encoder with locking arm and maffer clamp assembly (cable end attaches to Scorpio MDR)

o 24ft Kevlar belt (runs along dolly track)

o 2 modified maffer clamps (for the Kevlar belt)

o 2nd full size pelican case

 

A great value at nearly half the original cost, with thousands of dollars worth of cables and specialized machined brackets.

Asking $18,000 Contact stewartwhelan@mac.com