Jump to content
John Hatcher

Any good Atamos Shogun mounting options on the Ultra2?

Recommended Posts

Has anyone found good way to mount the Shogun low on the sled either directly on and perpendicular to the center post, or off the monitor rods? It just gets cumbersome up top by camera and everything I usually have going on up there with cables, motors and what not.

 

 

Share this post


Link to post
Share on other sites

Yes, smallrig does have a 15mm offset 1/4 20 that might do it. Would still really love a post mount of some sort though... Will see if anyone else has a secret. Thanks Victor!

Share this post


Link to post
Share on other sites

Ultra 2 monitor rods are not the same spacing as normal 15mm lightweight rods. not sure if they are even 15mm

 

Tiffen makes weight mounts that you could try and they also have a return monitor mount that is made to work on the monitor rods.

Share this post


Link to post
Share on other sites

I'll check that out Alan. I know small rig has a rod offset 1/4 inch clamp, but it's 15 mm and those monitor rods are a little bigger...

 

You're right Alfeo, the spacing is different and Tiffen does have a block that will fit, but that's too expensive for me just for the shogun.

Share this post


Link to post
Share on other sites

Any luck on Frankensteining a solution? And I can confirm that the Clipper monitor rods are 16mm and I think the spacing just might be a bit over 100mm.

 

At this I'm banging my head against the wall to figure this out as I want to attach a Shogun Flame to my Clipper24 rig.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×