Jump to content

Recommended Posts

  • Premium Members
Posted

Hi,

I'm upgrading my center post and I would like to switch my cable to my new post. i'm going from a Pro1 to a Pro2 post. is there an other way to remove the cable than removing one of the Lemo Plug?

thanks

  • Premium Members
Posted

Hugo, Does your Pro 1 post have the threaded connectors top and bottom, and LEMO connectors on both sides? If so, it is absolutely possible to remove the connector with a snap-ring removal tool, and a few minutes of time.

 

Simply remove the radial screws (either 6 or 9, depending on the post type) around the top and bottom of the post and slide out the threaded ends. Each threaded end has a retaining ring inside of it (it's a different color than the aluminum, usually silver or gold) with 2 holes in it. See picture below for what it looks like. Use a set of retaining ring pliers or snap ring pliers (different names for the same tool - also see pictures below) to remove it. Upon removing one, the cable will slide through the threaded end piece. Do the same for the other side, and the cable will be free.

 

Snap ring pliers or retaining ring pliers should be available from any big-box hardware store (Home Depot or Lowes or the like), or can be ordered on Amazon. They're a quite useful tool for PRO rigs, as PRO uses snap rings throughout their rig.

 

If you have any issue with following these steps, let me know, and I'll see if I can find time to take apart my sled and take some pictures of the parts for you.

post-1165-0-23974800-1482516643_thumb.jpg

post-1165-0-64315200-1482516781_thumb.png

post-1165-0-98472300-1482516786_thumb.jpeg

  • Premium Members
Posted

Hi,

thanks for the replies, it went really well with the Pro 2 post, but the Pro 1 post has "studs" instead of screws on top and bottom of the post. I don't know what to do with those... here are pictures of my Pro 1 qnd 2 post. I just don't want to break anything, i've tried to pull but nothing will comme out... I don't want to break anything!

thanks

post-12107-0-27073400-1482582024_thumb.jpg

post-12107-0-45933900-1482582081_thumb.jpg

  • Premium Members
Posted

Hey Hugo. Unfortunately, your are SOL:( I had the same post and it doesn't come apart. I tried really hard, but after talking to Jack @ Pro, it wasn't meant to come apart.

 

Sorry to be the barrier of bad news.

 

Cheers,

Kelsey W.

 

  • Premium Members
Posted

Hey Hugo, the only solution is destroying the pin by DRILLING IT!!! The hole is already in your post. You just need to destroy the pin inside it with a drill press!

  • 1 year later...
  • Premium Members
Posted

Hi Hugo, those pins are pressed in there so you can also trying pressing them out as well. You will have to make obvious allowances for the threads on the inner and outer post receivers so they don't get crushed. Just make sure the post is supported, the threads are elevated off the mounting plate surface, and the post is level to the press.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...