Jump to content
Aaron B. Brown

Digital Bartech Unit w/ Preston DM2 Motor

Recommended Posts

Listing my back-up digital Bartech receiver and hand unit with a DM2 motor.

 

Package comes with:

Bartech HU

Digital Bartech Receiver

Preston DM2

Motor cable

P-tap power cable

Pro to digital Bartech power cable (will have converted if needed)

 

I will include case and Jerry Hill PAM mount (w/ standard D-clamp plus PAM offset x1)

 

New this is $5,915. Looking to get $4,730.

 

This is a great starter unit or can be used to give additional iris control.

 

Photos to come soon.

 

PM me if interested.

 

  • Upvote 1

Share this post


Link to post
Share on other sites

Hi Aaron,

 

I may be interested in the bartech package including both motors. Is the package still available and if so do you have a link to pictures available? Please let me know.

 

Thanks,

Mike

Share this post


Link to post
Share on other sites

Still available. Listing both units now including the additional gears. I am willing to split up package as well.

The foam is shaped for two hand units and the two motors. The receivers lived on my sled mostly so I kept them there. When not in use I kept them in a different AKS case. I will include a new foam set so that you can shape it how you like.

The lens strips have been stained so I'll include 4 new ones.

The DM1x is in pristine condition and was used far less than the DM2.

The DM2 is in excellent condition but well used. You'll notice some marks from wear and tear but the motor functions flawlessly.

The .60M gear is missing 1 screw which I will replace.

Power setup:
I have a 2 pin Pro - Bartech Y power cable (not pictured here as I had sent it to get re-wired for 3pin pro - Bartech Y power). I have put a hold on the re-wire. This setup allowed for me to power both units from my sled (the Y is necessary because you cannot daisy chain the digital units as you can with the analog units); but also power either one unit or both units from P-Tap. The joint in the P-tap cable allowed me to switch out cables but also allows for a longer run if we need to do so with the build.

PM me with any questions.

post-11413-0-61664200-1500661768_thumb.jpg

post-11413-0-75410500-1500661778_thumb.jpg

post-11413-0-95487900-1500661797_thumb.jpg

post-11413-0-94315000-1500661811_thumb.jpg

post-11413-0-91527000-1500661822_thumb.jpg

Share this post


Link to post
Share on other sites

×