Jump to content

New Tranmitter


Recommended Posts

  • Premium Members

Demoed this on the movie I just finished. Liked it enough to purchase one. Contact David Hable @ Cramped Attic (604)254-8619. Specify which ant. you want. I went with a BNC. Channels 14-69.

10-36VDC. PRO cable compatible. What else can I say, same size as the Modulus and a nice replacement or backup without the headache. David is a nice guy and will listen to complaints or compliments(i.e. suggestions on how to make it better).

 

Dave Thompson

post-1152-1192992529_thumb.jpg

Link to comment
Share on other sites

  • Premium Members

I just purchased one of these transmitters. I am currently doing an arricam job that had a canatrans on it. When we swapped it out, the cramped attic transmitter was as good or better than the canatrans. I will be using it every day in New York City until the movie wraps in December, I will post more info after I have used it for a few weeks. The stock antenna (non bnc connector) is very small and nice, the unit itself is quite small, much smaller than the canatrans. Great product so far.

 

Denny

Link to comment
Share on other sites

  • Premium Members

Got one this week. Will try it out next week and post my review.

 

One good thing for modulus owners : you can use your modulus cables with it, it has the same pin configuration on the hirose connector. Also sends audio. So to complete Dave's post: the sender has the Hirose connector found on Modulus and David Hable can offer the PRO cable that sends video and power thru the same cable.

 

 

Model is VAT-25.

 

Specs (from manual)

RF power output : +20dBm +/- 2 dBm

Spurious signals: >40 dBc

Phase noise: -75 dBc/Hz at 500 KHz offset

DC in: 10/36 VDC

Reverse polarity protected

Channel 14/69 UHF

Video in: 75 ohm Composite NTSC 1 Vp-p

Current dram : <350mA

Frequency stability: +/- 20 PPM

Audio in: Line level 200 to 250 mV RMS

Operating temp: -20/+85 Celcius

Weight is 130 g

Aluminum housing

dimensions: 7.8 X 5 X 2.5 cm

 

2 year warranty on parts . The up and down arrows selects channel and locks the channel if you press both buttons for 3 seconds. On/off switch at the bottom.

 

cheers.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...