Premium Members Matt Kearney Posted December 16, 2007 Premium Members Report Share Posted December 16, 2007 Hi Guys, Anyone know the pin configuration for the preston mdr 2 to aaton xtr run cable. The aaton end is 2 pin lemo which is obvious, but im not sure which pins on the 12 pin lemo at the mdr2 end. Any ideas? Thanks guys. Quote Link to comment Share on other sites More sharing options...
Premium Members Matt Petrosky Posted December 16, 2007 Premium Members Report Share Posted December 16, 2007 Preston MDR-2 to Aaton 2-pin Lemo should be: Aaton Pin 1 GND to Preston Pin 1 GND Aaton Pin 2 START (Relay Trigger) to Preston Pin 4 Cam RUN (Active Low) This is assuming the 12pin Lemo FGG.2B on the MDR-2 and the 2pin Lemo FAA 0S (I think) on the Aaton. You can also trigger the Aaton via the 8pin and I think also with the 6pin. DOUBLE CHECK THE ABOVE WITH PRESTON--I WOULD. Good luck, Matt Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.