Seitz Follow Focus Pinout

[charlesneufeld]

Hey Guys,

 

Do any of you have the pinout for the DB9 connector on the 8720A receiver??

Also, perhaps the 4 pin lemo connectors on the Servo amp(8725A) aswell?

 

I have looked in the manual but no luck... <_<

Thanks Alot!

 

Charles :)

[Brad Hruboska]

Charles...... call seitz or.......

following my oldest diagrams here... model 2 era......

pin 1 All lemos is red... +12 v which feeds to D connector pin 7 use double gauge to connect to handle the amperage draw if you are making a cable of any length.

Channel 1 lemo

pin 2 feeds to pin 5 on D connector

pin 3 feeds to pin 3 for ground .

pin 4 NC

 

Channel 2 lemo

pin 2 feeds to pin 8 on D connector

pin 3 feeds to pin 3 for ground

pin 4 NC

 

Channel 3 lemo

pin 2 feeds to 9 on D connector

pin 3 feeds to pin 3 for ground.

 

contacts used for motor control on the "D" connector are, 3, 4, 5, 7, 8, 9

hope this helps.

 

 

 

:blink:

[charlesneufeld]

Hey Brado,

 

Thanks so much :) , I will call seitz to make sure it is all good. I suppose I could also open up the units and derive the pinouts from there aswell.... :ph34r:

 

Thanks again!

Charles